How To: Set Up your Reach RS2+ Base over a Known Point using State Plane Coordinates

by Shannon Whitsett
  1. In the Emlid Flow app, go to Survey and select the + to start a New Project.
  2. Choose your Coordinate system. Select the List Menu icon to the bottom left and add a New point.
  3. Change the Coordinate system to Local. 
  4. Add your Easting, Northing, and Elevation; then Save the point.
  5. Go to the Receivers tab and select Refresh. Connect to your base and then select Settings. 
  6. Select Base mode, Configure, and then Choose From Project. 
  7. Choose the coordinate from your project. On the Confirm base position page, select Apply, and then Save.
Back to News