XGRIDS Lixel K1 and L2 Processing with Control Points

In cases where you may not have RTK data on your scanner, you may want to tie it down to control.  You'll need to shoot in the targets with an RTK GNSS receiver or total station.  

During scanning you will set the scanners GCP plate on the target and press Control Point.

Then, press the plus button. 

Press OK. 

And repeat for additional control points. 

After collection, we'll use LixelStudio to process.

In LixelStudio go to Processing > Project Processing

Select the project file and import your GCP CSV file.  Tap GCP edit.  

The numbering on the matching and referenced control points should match.  Press OK

You should receive a message that the selected control point coordinates are correct.

Press Start to begin processing. 

After processing is complete you will receive a GCP accuracy report.