-
by Shannon Whitsett
The DJI Zenmuse L2 integrates frame LiDAR and a 4/3 CMOS RGB mapping camera which provides more precise and reliable geospatial data acquisition. D...
-
by Shannon Whitsett
The purpose of this exercise was to compare the range of the Emlid Reach RS3 LoRa radio and the Harxon UHF radio in a wooded area. We tested the ra...
-
by Shannon Whitsett
The purpose of this exercise was to compare the range of the Emlid Reach RS3 LoRa radio and the Harxon UHF radio in relatively flat and unobstructe...
-
by Shannon Whitsett
Below is a guide on how to program your Harxon external radio to broadcast your base corrections over 450 MHz Trimtalk ™. This can extend your rang...
-
by Shannon Whitsett
Below are instructions on how to use your Emlid Reach RS2+ or Emlid RS3 receiver as a base for your RTK drone. Compatible drones include but are no...
-
by Shannon Whitsett
Presented here is a full mission walkthrough of the DJI L2. We show the preparation, execution, and processing of a LiDAR mission with ground check...
-
by Shannon Whitsett
The following recommendations will help users avoid common issues when using their Emlid Reach RS2+, Emlid RS3, or RX with their mobile device or P...
-
by Shannon Whitsett
This guide covers processing an L2 LiDAR point cloud in DJI Terra, some of the tools available for measurements and annotations, and exporting your...
-
by Shannon Whitsett
Tutorial on using NGS's OPUS-S Beta with Emlid Reach receivers
-
by Shannon Whitsett
This article is an overview of the user interface within MicroSurvey's FieldGenius for Windows with detailed descriptions of the Toolbar icons. It ...
-
by Joe Douglas
There is a lot to sift through in the Operation Guide for Zenmuse L2.
The guide will give you the hard specs on the LiDAR as well as a good explan...
-
by Shannon Whitsett
We recommend MicroSurvey FieldGenius for Android to our customers who need a fully featured data collection software to pair with their Emlid Reach...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
