by Pat Douglas
July 31, 2023
Initial Update for Reach RS2+ (smartphone, tablet)
On your smartphone or tablet, go to Settings, Network & internet, and then Wi-Fi. Connect t...
by Pat Douglas
June 1, 2023
On occasion clients run entire projects only to find out that the deliverable was requested in a different coordinate system than what was used. Using the data gathered, Emlid Flow, and digital spreadsheet software, we can convert all of the data into the coordinate system that was requested in just a few steps.
by Joe Douglas
February 1, 2023
We will regularly update this page in order to keep you informed on changes to Emlid firmware and software for products including the Emlid Reach R...
by Shannon Whitsett
January 6, 2023
As an alternative to transferring logs via email, you may transfer logs such as RINEX or UBX directly to your computer. These logs may be used for ...
by Shannon Whitsett
January 6, 2023
RS2+
RS2
Multi-band network receiver;
Tracks: GPS, GLONASS, Galileo & BeiDou
√
√
√
√
LoRa Radio
√
√
Data loggi...
by Shannon Whitsett
January 6, 2023
When you purchase an RS2+ with MicroSurvey FieldGenius for Android and request setup, we will set your RTK system up so that it is ready to go out ...
by Shannon Whitsett
January 6, 2023
When you purchase an RS2+ with MicroSurvey FieldGenius for Android and request setup, we will set your RTK system up so that it is ready to go out ...
by Shannon Whitsett
January 5, 2023
In the Emlid Flow app, go to Survey and select the + to start a New Project.
Choose your Coordinate system. Select the List Menu icon to the bot...
by Shannon Whitsett
January 5, 2023
RX
RS2+
Multi-band network receiver;
Tracks: GPS, GLONASS, Galileo & BeiDou
√
√
√
√
LoRa Radio
-
√
Data logging...
by Shannon Whitsett
January 5, 2023
In the Emlid Flow App, connect to the RX over Bluetooth.
Settings:
Correction input: During initial setup, add your profile information. When togg...
by Shannon Whitsett
January 5, 2023
Before you begin, using the Emlid Flow app, set the RS2 correction output to Local NTRIP.
Power up the Mavic 3 and go to Flight Controller Settin...
by Shannon Whitsett
January 5, 2023
Before you can activate mobile data, the SIM card must be installed in the RS2+.
Connect to the RS2+ over Wi-Fi.
Open Emlid Flow, go to Settings,...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device